Simon XT User Guide
19
Top Level Menus
System Programming
To enter system programming mode, do the following:
1. Enter the system menu.
2. Scroll up/down to System Programming, then press OK.
3. The panel displays Enter code.
4. Enter your master code, then press OK.
At this point, you are in the System Programming submenu. At this level, the following items are
accessible:
• Access codes
• Timers
• Siren options
• Light control
• System tests
Access codes
There are three types of access codes: master, user and duress.
Master code
The master code is your most powerful code and can be used for all user operations including
programming. The initial value of the master code is 1234. To change the master code, do the
following:
1. Enter the System Programming menu.
2. Scroll up/down to Access codes, then press OK.
3. Scroll up/down to Master code, then press OK.
4. The current value of the code now ashes.
5. Enter a new code (use correct length), then press OK.
6. Press Status repeatedly to exit.
User codes 1 to 8
There are eight user codes, which can be used for many user operations, but not subdisarming,
programming, or bypassing sensors.
To change a user code, do the following:
1. Enter the System Programming menu.
2. Scroll up/down to Access codes, then press OK.
3. Scroll up/down to the user code you want to change, the press OK.
4. The current value of the code now ashes.
5. Enter a new code (use correct length), then press OK.
6. Press Status repeatedly to exit.
Initially, all user codes are blank. A user code can be deleted by pressing Disarm while the code is being changed.
Comments to this Manuals